Browse Standards
IEEE Standard Criteria for Class 1E Power Systems for Nuclear Power Generating Stations - Redline
Class 1E portions of ac and dc power systems and instrument and control (I&C) power systems in single-unit and multiunit nuclear power generating stations are covered in this standard. The provision of criteria for the determination of Clas...
IEEE Test Procedure for Charging Inductors
Provides standardised methods of determining the electrical parameters of charging inductors used in radar transmitters, linear particle accelerators, and similar equipment, and provides a standard testing procedure.<<ETX xmlns:mml="http://...
IEEE Test Procedure for Evaluation and Classification of Insulation Systems for Direct-Current Machines
Insulation systems for direct-current machines are classified in accordance with their limiting temperatures as determined by test rather than by chemical composition. The intention is to classify according to the recognized A, B, F, and H ...
IEEE Recommended Practice for Auxiliary Devices for Rotating Electrical Machines in Class I, Division 2 and Zone 2 Locations and Class II, Division 2 and Zone 22 Locations - Redline
This recommended practice applies to the application and installation procedures of auxiliary devices in or on electric rotating machines that are employed in hazardous locations classified as Class I, Division 2 and Zone 2 and Class II, Di...
IEEE Standard for Electronics Power Transformers
Application guidance and test procedures are given for power transformers and inductors that are used in electronic equipment and supplied by power lines or generators of essentially sine-wave or polyphase voltage. Provision is made for rel...
IEEE Standard for Electric Couplings; Part I - General, Rating, Performance Characteristics; Part II - Test Procedures
Electric couplings are widely used to transmit mechanical torque from one rotating member to another. They are distinguished from mechanical couplings in that their torque transmitting capability is initiated, and is frequently controlled, ...
IEEE Recommended Practice for Precision Coaxial Connectors at RF, Microwave, and Millimeteter-wave Frequencies-Part 3: Connector Effects, Uncertainty Specifications, and Recommendations for Performance
The P287 series of documents presents the combined efforts of IEEE P287 Working Group that reflect the knowledge and experience of leading specialists in the development and measurement of precision coaxial connectors for RF, microwave, and...
IEEE Recommended Practice for Precision Coaxial Connectors at RF, Microwave, and Millimeter-Wave Frequencies--Part 2: Test Procedures
The IEEE 287 series of documents presents the combined efforts of IEEE 287 Working Group that reflect the knowledge and experience of leading specialists in the development and measurement of precision coaxial connectors for RF, microwave, ...
IEEE Standard for Precision Coaxial Connectors at RF, Microwave, and Millimeter-Wave Frequencies--Part 1: General Requirements, Definitions, and Detailed Specifications
The IEEE 287 series of documents presents the combined efforts of IEEE P287 Working Group that reflect the knowledge and experience of leading specialists in the development and measurement of precision coaxial connectors for RF, microwave,...
IEEE Recommended Practice for Measurement of Power Factor Tip-Up of Electric Machinery Stator Coil Insulation - Redline
Covered in this recommended practice are power factor and power factor tip-up testing of stator coils and bars for use in large electric machinery. This document also defines power factor, tangent delta, dissipation factor, and conversions ...